Dake 83102-2
Dake Bandsaw Model LE10A, 220-volt 3-phase
Dake Bandsaw Model LE10A, 220-volt 3-phase
Dake Bandsaw Model LE10A, 220-volt 3-phase
Machine Type: Horizontal scissors type
Capacity Bundled: 4-½ inches – 7 inches wide, 5-½ inches high
Drop Length Possible: Less than 2 inches
Blade Size: 138 inches x 1 inch
Blade Speeds: (Feet Per Minute) 88 / 130 / 177 / 223 / 262 F.P.M.
Feed Stroke: (Single) 3/8 inch minimum - 16 inch maximum
Multiple Stroke: 9 times (142 inches maximum)
Feed Type: Hydraulic hitch feed with vertical rollers, feed speed 16 inches in 6 seconds
Length Set Up: Front mounted handwheel, and DRO with large numeral digits.
Horse Power Blade Motor: 3 H.P.
Hydraulic Pump HP: 1 H.P.
Coolant Pump Type and HP: Gear type – 1/8 H.P.
Hydraulic Oil Capacity: 5-¼ gallons
Coolant Capacity: 10 gallons
Vises (Quick set ratchet type): Hydraulic with blade forward clamping for minimized burr and with 1" throw
Vise Clamping Pressure: 600 pounds
Vise Ways: Precision ground and hardened
Work Table: Machined with chip clearance inserts
Hitch Feed Capacity: 2790 pounds with use of roller table
Hydraulic Pump: Hydraulics on demand (HOD) with minimum pressure start up
Head Feed: Hydraulic regulation with RPM compensation feed back
Piece Counter: 9999 piece with auto shut off
Rapid Head Approach: Sure stop hydraulically controlled
Blade Tensioning: Mechanical with preset locking ring
Electrical: CE approved / Thermo overload, low voltage protection, 110 control voltage
System Control: PLC
Warning Light: Yes
Auto Shut Off: Pieces reached, out of stock, blade slippage/breakage
Chip Brush: Speed synchronized
Foot Print: 76 inches x 69 inches (145 inches deep without roller support)
Roller Support with Vertical Roller Dimensions: 72 inches long x 16 inches wide
Work Height: 21-½ inches
Weight: 2645 pounds
Tool Kit: Standard – Includes screw drivers, wrenches and Allan keys
Spare Parts: Standard – Includes chip brushes and guide bearing replacements
Work Light: Standard
Machine Support Pads: Standard
Collective Hour Timer: Standard
Auger Style Chip Removal System: Standard
Guarding: Full hinged
Lubricant: Flood type unit built into the machine (Electric)
AMP: 20-amp service for 230-volt machine
Compressed Air: N/A (Clean, dry)
No customer comments for the moment.
Only registered users can post a new comment.